If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I don't see either method going over well, especially if it's in there pretty deep.
When I was 16 I worked for a locksmith as a summer job. I remember seeing him use these key extractors to get it out. Basically he stuck em in there, twisted each handle a few times and out the key came. Here's somewhere you can get em from
What position is the key in? If it is in the first then you should be able to pop the whole lock out. Otherwise, try to pry it out using two small, but strong pins or allen wrench.
The key was just in there..I guess number 1? Steering wheel is locked..I'll take a look again to see if there's any portion sticking out that I can grab with pliers or something.. how about the glue method?
I don't see either method going over well, especially if it's in there pretty deep.
When I was 16 I worked for a locksmith as a summer job. I remember seeing him use these key extractors to get it out. Basically he stuck em in there, twisted each handle a few times and out the key came. Here's somewhere you can get em from
What position is the key in? If it is in the first then you should be able to pop the whole lock out. Otherwise, try to pry it out using two small, but strong pins or allen wrench.
Half the key is broken in the ignition and the other half I have..I have second key for the car, I just need to pull the broken portion out..what's the best easiest/method for this? Any help would be appreciated..thanks
Leave a comment: