If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The cap serves a purpose, and helps keep the o-ring in place to seal the injector, and also directs the spray from the injector somewhat. Without it you are going to have a very high chance of a vacuum leak.
The cap serves a purpose, and helps keep the o-ring in place to seal the injector, and also directs the spray from the injector somewhat. Without it you are going to have a very high chance of a vacuum leak.
thank you very much...that's much better.
I did have the ring there so it's sitting in, nice and snug.
Anyway...I put everything back today (silly injector included)
what I did was replace my head gasket
and I put everything back right (at least I think)
However, the car does not turn on right now...but it does turn over...
I didn't put on my air filter or anything yet...Also I smell gas but I'm not sure if the pump has pumped enough into the injector's line...
what should I do to properly bring her back to life???
Comment