Things left to do for the e30...Zen/Mason.

[MR 325]

I checked out your front strut brace. Far from impressed.

I think you need to move on.

[smonkbmw]

And an oil pan guard for the M20 and M42...

sorry ejnight has this covered well i think.

[delatlanta1281]

How bout a beer an BS holder?

[george graves]

Extended range additional gas tank for under $100.

[delatlanta1281]

Really?
I can't wait for you to stop "modding" e30s.
Over the past three months you have complained, posted threads that never "show"' gains, and tested the patience of e30 owners. For what? A strut tower and some foam gaskets that peel off a week after installing?
I would think by now you would be supercharging or looking at a way to make a cheaper 5 lug swap.... but then again, it's late, and those two things are WAY beyond the reach of fabrication.
Give it up.
If you are at the point of trying to "man" a dead pedal, then it is def. time to throw in the towel.

[DCColegrove]

Oil filter cap for M42 to run oil cooler

Hmmm...

Not a very big market for it anymore but I have made sandwitch plate oil cooler blocks for the M42 in the past... there is a better way to cool the oil in an m42 though... But it takes a lot of Fab work.

[Hick]

Oil filter cap for M42 to run oil cooler

[DCColegrove]

Who would you recommend if I'm already running E30 M gear?

AKG makes a good set of spacers... Good price and quality.

[Ray Smoodiver]

Who would you recommend if I'm already running E30 M gear?

[DCColegrove]

Roll centre spacers

No safe and economical way to really do it for the regular e30s unlike the M...

It would have to be a complete control arm or a modified strut assy / knuckle... Too big $$$ for the DIY guys.

[Ray Smoodiver]

Roll centre spacers

[DCColegrove]

Have you decided if you are going to make a harness bar? I vaguely remember seeing a thread about that awhile ago.

We talked about it but it doesn't seem that there is enough interest to justify tooling up to do it.

nice Oil filter cap sensor housings guys. one with some Correct engineering and quality in mind. of course M42.M50.S50 ect

If you are talking about oil temp sensors this wouldn't be the "correct" place to put them.

[gearheadE30]

Have you decided if you are going to make a harness bar? I vaguely remember seeing a thread about that awhile ago.

[e30s52]

A Bar like the sparco tie down bar for aftermarket seats. Sorry I cant remember what it is called.

[Tree18is]

nice Oil filter cap sensor housings guys. one with some Correct engineering and quality in mind. of course M42.M50.S50 ect