SOMEONE HIT MY CAR!

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ColdAccord
    R3V Elite
    • Oct 2003
    • 5926

    #1

    SOMEONE HIT MY CAR!

    I work on the Elmwood strip in Buffalo. I'm sure none of you are familiar with it, but it's a bunch of shops, with a few parking lots throughout the series of blocks

    I work at a snowboard shop on elmwood. I walked to WIlson Farms to buy a drink, and the lot where I park my car is right before it. I go over to grab change out of my car, to see that the drivers mirror was pushed outward. I get pissed, and start running toward my car.

    only to find SOMEONE NAILED MY DRIVERS SIDE DOOR! right up near the fender. there are 4 scrapes above the molding, each about 1 foot long, all scrapes were down to the metal. below the molding were 2 more scrapes, one is 1.5 feet the other is 1 foot. and theres a huge dent there

    I'm so pissed. this sucks so bad. luckily that door needed to be worked on anyway, it's got some rust going where the molding is. But I covered it with black nailpolish so it wouldn't rust. I'm probably gonna get a replica m tec II kit in the summer and spray the whole car



    Originally posted by blunt
    can you get me a deal on cases of their (fiji) bottled water? i wash my 02 in that shit
  • 92 mtechnic cabrio
    Honesty is not the best policy!
    • Dec 2003
    • 4907

    #2
    OMG that sucks so bad man, I'm sorry :? , but maybe this was a sign, to get that mtech kit, eh? :o
    R.I.P 07/01/09 - 04/23/10 :(

    Comment

    • 318daily
      E30 Addict
      • Nov 2003
      • 507

      #3
      that's a big downer. no note or anything huh ?

      must have been some a-hole from the city. :(

      Comment

      • Super Eta
        E30 Mastermind
        • Oct 2003
        • 1884

        #4
        The previous owner of my car had the same experience.

        She was at a concert and afterwards she came out to find that someone had backed into the car and just drove off leaving no note or anything and it took out the tail lense, bent the trunk lid and smashed the rear in a bit, i have since fixed the tail lense and took out some of the damage but the whole ass end needs to be pulled.

        Pictures.

        Before:


        After:



        Had to hammer out some of the metal in order to fit the tail lense into place and yes i used the right tools i did not go using the toolshop hammer it was an autobody hammer and tools

        Comment

        Working...