Since my last Members Rides thread I've made a ton of changes, most noticeably the wheels and suspension, but there was also a dash swap and some maintenance along the line, oh and there's a Luke Box in the works as well.
Don't mind the busted ass windshield (being replaced Monday) or the missing gauge cluster bezel (was cracked in half, replacement soon), or the missing center caps (gotta finish polishing).
Built up some coils with GE group buy springs:
IMG_0457 by m_colby, on Flickr
Bought some played out wheels and test fitted them:
RS test fit 2 by m_colby, on Flickr
After some sanding, painting, and polishing:
Refinished BBS RS by m_colby, on Flickr
And mounted:
Profile by m_colby, on Flickr
Front to Back by m_colby, on Flickr
Right Side by m_colby, on Flickr
Left Side by m_colby, on Flickr
And one of the fresh dash and Nardi wheel from Rennstall:
The Cabin by m_colby, on Flickr
Specs are:
Bilstein IX hds
Chopped Housings
GE 450/650 GB springs/adjusters
IE Race Camber Plates
IE Rear Strut Mounts
BBS RS131 16x8.5 et56
BBS RS018 16x9 et36
40mm 5x130 to 4x100 Adaptec adapters in the front
25mm 5x130 to 4x100 H&R adapters in the rear
Falken 512 205-45-16 front/rear
Notes: This isn't the final ride height, still gotta dial it in, coils will still go lower by quite a bit. Need to get a skid plate setup as well.
Link to build thread for those who may be interested http://www.r3vlimited.com/board/showthread.php?t=153509
Don't mind the busted ass windshield (being replaced Monday) or the missing gauge cluster bezel (was cracked in half, replacement soon), or the missing center caps (gotta finish polishing).
Built up some coils with GE group buy springs:
IMG_0457 by m_colby, on Flickr
Bought some played out wheels and test fitted them:
RS test fit 2 by m_colby, on Flickr
After some sanding, painting, and polishing:
Refinished BBS RS by m_colby, on Flickr
And mounted:
Profile by m_colby, on Flickr
Front to Back by m_colby, on Flickr
Right Side by m_colby, on Flickr
Left Side by m_colby, on Flickr
And one of the fresh dash and Nardi wheel from Rennstall:
The Cabin by m_colby, on Flickr
Specs are:
Bilstein IX hds
Chopped Housings
GE 450/650 GB springs/adjusters
IE Race Camber Plates
IE Rear Strut Mounts
BBS RS131 16x8.5 et56
BBS RS018 16x9 et36
40mm 5x130 to 4x100 Adaptec adapters in the front
25mm 5x130 to 4x100 H&R adapters in the rear
Falken 512 205-45-16 front/rear
Notes: This isn't the final ride height, still gotta dial it in, coils will still go lower by quite a bit. Need to get a skid plate setup as well.
Link to build thread for those who may be interested http://www.r3vlimited.com/board/showthread.php?t=153509
Comment