If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
So I spent my night messing with my suspension got the camber dialed in to where I want it and the ride height as well. May god help me! But it looks so good low. Still haven't driven it so it still needs to settle a bit also doesn't have a passenger seat. Tucking all the way around.
Update! Installed my camber plates. Finally had time to do them. Going to tackle the rear top mounts today and fix the ride height and camber up front as well.
While I was there I decided to install my new valve cover and new gaskets. Found out my valve cover hose was ripped on both ends so I pulled one off my parts car.
UPDATE! Got the dash in still need to run my sound system wiring then I'll be able to shampoo the carpet and put my seats and mats in.
Don't mind the cluster lol I put in my new si board and now my tach doesn't work. So now i have to figure out why because it worked before with the old si board.
UPDATE! Got the dash in still need to run my sound system wiring then I'll be able to shampoo the carpet and put my seats and mats in.
Don't mind the cluster lol I put in my new si board and now my tach doesn't work. So now i have to figure out why because it worked before with the old si board.
Leave a comment: