If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
The motor is from a e36 325..
He has a .140 mls head gasket, arp studs, ms3 v3, 24x12x3 IC with 3 inch intake pipe and 4 inch exhaust, holset hx35.
heres a few more pics...
theres still a lot of work to do.
we just dropped the motor in last weekend..
manifold is at the shop getting cut, flip, twisted and turned...lol
quick update, nothing major.
I mocked the mani up on my motor since it is out of the car.
the mani is one of the cheap bottom mount e36 manifolds.
so for it to work as a top mount the mani needs to be cut and turned a little bit.
heres a few photos of it.
hope to have it all welded up this week and start on the exhaust set-up.
wiring harness will be here this week also, so we can get a lot more work done...
Comment