This is Simone...
Collapse
X
-
-
I love this car but I just can't get pass those rims, they just don't fit this beautiful machineLeave a comment:
-
Sexy, I love hard tops. My Brother has a black one, it completes the car 100%Leave a comment:
-
So I proceeded to cut the old e30 switch harnesses off and prepared to solder on the e36 ones.
The solder attempt failed as my soldering iron couldn't get hot enough to get good penetration. So I ended up using butt connectors to connect the e36 bases to the old wiring.
Tested all the switches and one of them doesn't light up :(
I'll solder in a new bulb or swap out a light switch another time. So I put everything back together I'm pretty happy with the result
Before
After
Last edited by MC Hammered; 02-28-2016, 10:09 PM.Leave a comment:
-
I got sick and tired for the intermittent e30 window switches so I hit up the scrapyard and picked up some e36 window switches.
How it looks now
So I removed the center console to start the process of fitting in the e36 bezels.
This is when I try to figure out which is worse... the O or the C of OCD.
To give you an idea the following took 3 hours to do.
Made some templates
Driver side done
Found out the passenger side is harder to do since the bridges have small metal tabs underneath them to provide support. So if you press too hard or apply too kmuch pressure something is going to break.
Passenger side done
*sigh*
Now I wish I did the passenger side first so I could have matched the gaps.
Last edited by MC Hammered; 02-28-2016, 10:10 PM.Leave a comment:
-
Latest rare goodie from Levent
Pictures of the collection
Closeup of the real moneypit
Aftermarket 'Love the Ride' windscreen
OEM BMW windscreen
As you can see it does fit a tiny bit better.
Last edited by MC Hammered; 02-28-2016, 10:13 PM.Leave a comment:
-
Looks good but I'm on the fence about the wheels on there. They did turn out nice though. Maybe if they were an inch bigger with some wider lips.Leave a comment:
-
Thanks!
I took the corner a bit too quick to reach out and give you an acknowledgment :pimp:Leave a comment:
-
Hi MC,
Car looks sweet,
I too have a set rims that looks like yours, BBS RF's aka Design 5000, they're 4x114mm :(

Can you please take a few pics of rear corner trims?
I need to trim my non-mtech pieces, sort of same as you need to do here, just below bumper ...
Leave a comment:
-
-
It is a Fox exhaust with the tip cut and rewelded on at an angle to match the bumper opening.
They are an older generation Dunlop summer tire in 225/45/16 size. I like the beefier look vs. stretched
Thanks!Leave a comment:

Leave a comment: