After a year of searching, an Alpineweiß story

[iwantspeed]

My friend bob "blackout" got me a z3 rack 031 part number 2.7 ratio linear rack


soooooo excited about this
E30 update by ALEXANDER RENGIFO, on Flickr

[iwantspeed]

Garage update


Garage update by iwantoffroad, on Flickr


Garage update by iwantoffroad, on Flickr


Garage update by iwantoffroad, on Flickr


Garage update by iwantoffroad

[jeenyus]

Did I miss where you finished your catch can project? How's it working out for you on an NA car? Been thinking about it.

[paynemw]

Where did you get all of those rebuild parts for the axles?!

[iwantspeed]

Did I miss where you finished your catch can project? How's it working out for you on an NA car? Been thinking about it.

It didn’t work well enough and I removed it.

Where did you get all of those rebuild parts for the axles?!

I buy almost everything from rmeuropean.com

And I bought the redline cv2 grease in the jar form from amazon.
1 jar is more than enough for all 4 cv joints

[iwantspeed]

Weighed the car

Corner weight by iwantoffroad, on Flickr


Corner weight by iwantoffroad, on Flickr


Corner weight by iwantoffroad, on Flickr


Corner weight by iwantoffroad, on Flickr


Corner weight by iwantoffroad, on Flickr

[-J-]

Are those corner weights with or without driver weight?

If it's with driver then damn, my car is fat, haha.

[iwantspeed]

Are those corner weights with or without driver weight?

If it's with driver then damn, my car is fat, haha.

no driver

[iwantspeed]

hanging out at my friends shop.

IMG_6776 by ALEXANDER RENGIFO, on Flickr
IMG_6775 by ALEXANDER RENGIFO, on Flickr
IMG_6774 by ALEXANDER RENGIFO, on Flickr
IMG_6773 by ALEXANDER RENGIFO, on Flickr
IMG_6772 by ALEXANDER RENGIFO, on Flickr
IMG_6764 by ALEXANDER RENGIFO, on Flickr

[Zambuzan]

What a clean-looking e30! Props!

[iwantspeed]

thanks

[jeenyus]

did you remove the texture from the lower valence?

[iwantspeed]

i did not

[iwantspeed]

hate the new forum layout. dont post much anymore. im just driving my e30 and putting miles on it.

doing some maintenance on the e30.

timing belt
tensioner
water pump
spark plugs
air filter
fuel filter
fuel lines
oil cooler lines
oil pan gasket

Untitled by ALEXANDER RENGIFO, on Flickr

i drilled out the oil pan drain plug and used a time cert.
Untitled by ALEXANDER RENGIFO, on Flickr

Untitled by ALEXANDER RENGIFO, on Flickr

converted the stock oil cooler lines to AN lines. and had a shop braze on an fittings to the bmw hardlines
Untitled by ALEXANDER RENGIFO, on Flickr

i tidied up the wiring later on.
i was mocking up the oil cooler lines in this picture to get the oil filter to point at the ground but didnt like how close the hoses where to exhaust manifold. so i rotated the housing back to the stock orientation
Untitled by ALEXANDER RENGIFO, on Flickr