If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
more work on the interior complete and some wiring you cant see. purchased a painless phantom keyless system for the car and got it wired up. Also bought a new used dash that wasnt great but way better then what the car came with. I followed the dash repair guide on this site and while not perfect, it looks great
yeah, meant to ask you what mounts you used for the e12, just have the standard bav motor mounts right now. after looking at your build looks like the e12 stearing box sits at more of an angle so it sits right under the mount? regardless I should be able to make it work
finished stripping the engine down today and will be dropping the heads and block off at the machine shop on wednesday. Bolted on JakeB's mounts and test fit the block aswell. good news is it fits, bad news is I had to remove the steering box to do so
received my motor and trans mounts today, big thanks to JakeB! They are the mounts he produced for the e12 lsx swap and should do the trick. I also received my carpet yesterday, 3 yards of wool multiloop carpet from GAHH.
Got more done on the interior since the last post. Been TDY for the last month so it was good to get back in the garage. I finished laying down the POR-15 on the floor and started putting down raammat today. Also bought a pair of Recaro LS seats, they're a bit rough but hopefully I can clean them up
Leave a comment: