My AC Schnitzer tribute touring.

[ThatOneEuroE30]

Know anyone that needs a ac schnitzer strut bar lololo

[Der Ruffian]

Cleaned and resprayed the AC Schnitzer carbon cover the last couple of days.

[Der Ruffian]

More Pictures.
Not done yet, but almost.
Need to replace the schnitzer front and rear, and delete that ugly towhitch.

[ThatOneEuroE30]

Just traded my Alpina E34 cluster for an AC Schnitzer strutbrace exactly like this one, and an AC Schnitzer M20 manifold

Well that makes 4 of these strut bars known. Just wish I could sell mine.

[Der Ruffian]

Well it fits, and it clears the M50 wiring harness, so I don't care if it's from an E36...
The other ACS strutbrace won't clear the wiring harness.

[Der Ruffian]

It fits an E30 ;-) I traded my Alpina cluster for that, and an original AC Schnitzer manifold for M20 plus an AC Schnitzer footrest (Don't know if that's a knockof, but don't care because I got the two other Things.)
I was in doubt about those mirrors, but I actually like them so much now, that I'll buy a set for my 2 door ACS.

[Gregs///M]

Let me know if you need a replica AC cluster. I've built one before but have some ideas on how to make it look more like the original AC. Pics on my website.

[e30m3s54turbo]

I like the mirrors on the touring. The AC Schnitzer strut bar you posted in the pic look like for e36. I heard e36 could fit.

[Der Ruffian]

Just traded my Alpina E34 cluster for an AC Schnitzer strutbrace exactly like this one, and an AC Schnitzer M20 manifold

[Der Ruffian]

It's currently like this, after wrestling the wiper arms for 2 hours. They got stuck, while the car was in Winter storage.
But installed the new head lights on the drivers side, and a set of DTM mirrors in carbon.

And took that stupid M emblem of the grille, and installed a ACS one instead.

[Lake]

more updates!

[e30m3s54turbo]

The AC Schnitzer dead pedal looks good. Any more up dates?

[Der Ruffian]

Installed the ACS dead pedal last weekend, it sure looks good.

[Der Ruffian]

I'll try that.
Thanks for the tip :-)

[Farbin Kaiber]

You almost might want to clean it properly, leave the center logo, lightly sand the exterior areas, then mask and spray with a 2K epoxy clear and you should be able to save the logo, looks like not too much issue on it specifically.