Ive had my e30 for over two years, it started life as a 325es. I've been gathering parts for it for a while and im now finaly getting into the fabrication side of things. IT will have an 2.5 lt built s14. AP racing brakes, full 5 lug swap and a full DTM cage.

main hoop plates



The main hope was not in plane with each other so we had to bend one side. Well since the tube is 4130, 1 3/4, .090 wall it took alot of weight on one side. So much so we needed my sisters hummer to be driven over one end of the bar and we where still moving the car up and down.



The main Hoop is in



Next we did the rear strut tower bar, and the driver side X bar.



If anyone wants to know how to get the tubes to match u. I used one of these , and it eats hole saws





That was all for the first day.

Then I went to work on finishing up the rear

Rear subframe tie in





rear subframe and diff fully tied in.



Rear X and vertical supports done.



Tomarrow ill post the finished driver side A pillar bar.