If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
what kind of engine stands do you guys have, and what weight capacity?
i think i may have to get one soon and i'm looking for the best bang for my buck!
I have the T shaped stand, and I will tell you my m20 started to tip and I had the ketch it. I am a big guy and my brother ran out and helped me so no harm was done, but unless you can weld on an extra cross bar up front do not get it. Spending large amounts of time and money on an engine and then seeing it fall over and eat shit is hart braking.
How ever if you can weld or just want to bolt an extra piece of 2x2 square tube up front with some extra casters, the T shaped stand is cheap as it will get and does hold an m20 very well.
sigpic
"The bitterness of poor quality remains long after the sweetness of low price is forgotten."
In a recent issue of Hot Rod, they compared and tested the "cheapy" stands and the 1 ton I shaped one from HF withstood something like 2300lbs of force before the plate that the motor bolts to deformed. Nothing else broke or deformed, which is pretty impressive for an inexpensive stand. I have the I shaped stand and used 4 of the T shaped stands to build my rotisserie, so I can say they work as good as anything else out there at 3 times the money. Catch the T shaped one on sale and that is the best bang for your buck... and spend the money you saved on the motor!!!
Comment