Calling all Vapers.

[TurboJake]

Well... there's a lot to that. Voltage and resistance, airflow, and viscosity of juice, life of the coil and that wonderful china quality control...

Lets start with the device. That ego t... that's a variable voltage device right? It twist on the bottom? Also how old are these coils and when do you notice it start to burn. What ratio juice are you using ie vg/pg mix.

Sent from my SCH-I535 using Tapatalk 4

No, Ego-t is just a tank system. You're thinking the Ego Twist.

I loved my Ego-T. But moved on to clearomizers with the battery and was much happier.

The rest of your questions are highly variable. How much you toot per day. What juices you use (Flavorings, PG/VG/Etc). That, and the Ego-T atomizers I found to have QC that was all over the place. Some would be burny right off the bat. Then one will last 2 months without problem.

[Pantless Spency]

Yup . I make my own NET's (Naturally Extracted Tobacco) flavorings.
The process is pretty straightforward , but costly and time consuming. Here is why.

I start with a Liga Privada # 9 cigar (approx 13 dollars a stick). Unwrap the wrapper, binder, and filler.

Then take all those leaves and hand shred them. Place them into a mason jar then add a 50 / 50 blend of PG and VG that equals 60 ml to the leaves and then use a wooden dowel to mash up the leaves , stir and essentially get all the tobacco leaves to soak up the solution.

Once this is completed to my satisfaction. I seal the mason jar with its lid and place in a crock pot with water at about 2/3'rds full. Turn on crock pot with low heat and allow to cook overnight. Then allow to cool in the morning. Open the jar when cooled and stir/ agitate the leaves and solution. It begins to look like light molasses.

Then repeat the cook the next evening. After that cook. Remove and cool. Take unbleached coffee filters (there brownish) and pour the leaves and solution into a coffee filter that is placed over another freshly sanitized mason jar. Allow solution to filter through the filter and then squeeze the leaves into the filter pressing downward lightly. Then fold the edges of the coffee filter down over the outside and put the lid on the mason jar.

Allow a full day for the juices to flow through the filter. Remove lid and discard the tobacco leaves and filter. Then I sometimes filter up to 3 more times the same way. See how this is time consuming? :p

Then the real time consuming part. Leave the solution in the sealed mason jar for 2 weeks before using the extract.

I then add a specific amount of this flavoring to my preferred mixture of PG/VG and then add cherry blossom flavoring. Its like an amazing semi sweet cherry tobacco and blows away the other off the shelf tobacco extracts and flavorings.

If you want a sample I can send you a 1/2 full 10 ml bottle. Just PM me. With this size of liquid you would need a dripper though cause its hardly enough for a tank.

Dude that super complicated but sounds rad as hell I would be down to try some of that. Don't have a set up yet but hopefully I'll be buying one when I get paid on Wednesday. Ill pm you! Thanks man.

[Pantless Spency]

MVP 2 is nice as a box mod, BUT remember that it has an internal rechargeable battery. Once that battery is spent then its not like you can just pop open a flap and slam in another battery and keep on vaping. Thats a downside!

I think you could plug into the charger and keep vaping , but if you have ever held a box with a cable hanging out of it and tried to move it around - Fugetaboutit. So even if it does function as a pass-through its really not worthy in my eyes.

Better off saving up a few bones and picking up a DNA20 device like the billet box or Man Cave Mods (wood) or a Hana Mod. Just search DNA20 on Instagram or the web and those devices typically will use a standard 18650 style battery. So when one is depleted in the unit , just pop it out and add another and keep on keepin on.

Yeah, the simplicity and value of the MVP 2 is what makes me want it, I've seen a few DNA 20 mods and that board is very impressive, I'll definitely take a look into some DNA 20 mods.

I'm just looking for something to vape out of, mostly at my desk or at home.

Have you seen the DNA 20 NES controller mod? So fucking cool haha. That's probably my favorite mod lol.

[Pantless Spency]

No clue.
It's an ego-t battery and a protank2.

Sometimes I can vape all day and sometimes it just burns and there's
nothing I can do about it.

Right now I switched to my normal small tanks until I burn.
there should be ones that don't burn. Can't be that hard to make right?

So I've read and done a lot of research on kanger protank 2's.

So the tank is a bottom coil and the juice naturally works it's way into the chamber where it is vaporized by the coil. Sometimes the protank 2 can't keep up with you, if your starting to get burnt hits it's because your not vaporizing any liquid, there's no liquid touching the coil. So a solution to help the lack of juice flow is to take a few non firing drags on it, not super hard just take a few drags or puffs without firing the button on your device. You should see air bubbles come out of the bottom of your tank and rise to the surface of your juice. I've experienced this while using a friends personal vape with a protank 2 on it.


Hope that helps.

[E30_Pare]

Same problem with the original protank. Cant vape it with low juice in the tank. Starts gurgling so need to equalize the pressure. Turn it upside down and unscrew it or add more juice.

Depending on your mix is a factor on how it hits. If your vaping 100vg need to remove 1 of the wicks on top of the coil or it will dry burn. 50-50+ pg you'll be fine. My experience with it however is thing eats juice like a monster. Find myself feeding it juice and fiddling it more than I'd like. Have had better success with the iClear30. Only upside to the kanger is its a better build with a pyrex tank other than that just sits with my vape gear.

[LowR3V'in]

They should have a tank where it's an open coil and it just drips on there
with no wick.

btw, on the protank2 it helped allot if I took off the rubber seal that goes over
the coil. It didn't leak and did help. still burned though.

Also the normal plastic tanks helped if I cut alittle notch on the rubber seal
to the wick.

[Vtec?lol]

Just got a kanger tank myself.

It takes a lot more fiddling however the hit is nice.

[e30vert]

Yeah, the simplicity and value of the MVP 2 is what makes me want it, I've seen a few DNA 20 mods and that board is very impressive, I'll definitely take a look into some DNA 20 mods.

I'm just looking for something to vape out of, mostly at my desk or at home.

Have you seen the DNA 20 NES controller mod? So fucking cool haha. That's probably my favorite mod lol.

Yeah I am pondering building one of the NES controller mods,but that's just for bling cause it suffers from the same issue of nit having a replaceable battery and once the battery is dead it might as well be a boat anchor. I may build one at some point cause the guy that started building them has a wait list that is months and months long.

[e30vert]

Same tank issues plague the DBox Puritank. Was hoping that it would be a better solution to the bottom coil tanks.

I am going to try an Ekowool wick and wind my own coil for the DBox tank while removing the upper flavor wick and that should help . Plus I can wind a lower ohmed coil for more cloud production. I may also drill out the two small side holes near the bottom threaded 510 connector.

I just received some of those tanks in my recent vape mail.

[E30_Pare]

ive tried sub ohm coils on my protank. Only problem is getting enough air flow to compensate.

[golde30]

You guys are way more fancy than me. Ego-C upgrade with a Kanger T3S does the job for me.

[psigti]

ive tried sub ohm coils on my protank. Only problem is getting enough air flow to compensate.

Air flow design on the protank sucks. Those two cuts on the bottom of the deck blow balls. I hear people like the evod more than the pro tank? I'm not sure how accurate that it. I had better luck with dripping attys, cartos/carto tanks (punched and unpunched) and novas when I was using that type of gear.

Sent from my SCH-I535 using Tapatalk 4

[E30_Pare]

When I had a Nova i thought it was absolute garbage. Didn't like or enjoy it for 1 sec.

[psigti]

In the end I didn't like any of those... hence going with high end rebuilds.

Sent from my SCH-I535 using Tapatalk 4

[E30_Pare]

Im looking at the Ithaka tank next. Hear good things