Calling all Vapers.

[E30_Pare]

I've had really good luck with my kayfun. I pretty much stick with 28 gauge kanthal 7/8 wrap micro coil and use a cotton wick. I'm not getting huge clouds like some people I have seen online but it's more than anything else I got. I keep it on my nemesis with a kick 2. I think I set the airflow the first day I got it and haven't touched that since. I put the coil directly above the airhole. Flavor is insane too. Actually a little too much early in the morning so I don't use it until mid day or so.

I'm still trying to build it :( may just be my juice needs to steep a bit more, but I'm getting better flavor out of my protank. I'll give it a chance tho. If all ese fail, i'll probably just get a Kraken. Have yet to try a genny.

[Jonnywachter]

my latest build, 28g twisted, 6 small wraps .34ohms. i get a decent amount of vapor but the flavor and juice last a bit longer than other builds i have done.

[campbellj25]

I have the Aqua for driving mainly or when I feel like not dripping.
Can lay on its side or upside down and it will not leak.
More vape then kayfun but little less flavor.
For the igo-w thats normal to have small holes but not good for vaping.
Mostly all atty needs to be drilled out.

For your burnt wierd taste, maybe its your first builds?

Well that's my first builds on a dripper. I built the coils the same as I do on my kayfun and it turns out great. I'm going to keep experimenting with it and try different types of coils.

i got a kayfun yesterday. Been trying to build it all day, but the flavor seems weak. I up the airflow and theres more vapor, but no flavor. I tighten up the draw, but the flavor isnt as strong as I expect. Tried micro coils, parallel, traditional, but nothing seems to work well. :(

I've had really good luck with my kayfun. I pretty much stick with 28 gauge kanthal 7/8 wrap micro coil and use a cotton wick. I'm not getting huge clouds like some people I have seen online but it's more than anything else I got. I keep it on my nemesis with a kick 2. I think I set the airflow the first day I got it and haven't touched that since. I put the coil directly above the airhole. Flavor is insane too. Actually a little too much early in the morning so I don't use it until mid day or so.

[E30_Pare]

im at 1 ohm on the kayfun

[Kev]

Sorry, I meant how low on ohms?

[mbonanni]

So sexy. Nice settup

Sent from my SPH-L710 using Tapatalk

[E30_Pare]

Must say i like the kayfun on a nemesis.




Sent from my iPhone using Tapatalk

[E30_Pare]

I vape the tank halfway up the bottom ring. If it start gettin dry i put my finger on the airhole to try and prime it.


Sent from my iPhone using Tapatalk

[Kev]

How low are you going?

[E30_Pare]

its an hcigar clone. The quality is really nice for what it is. Threads were sharp no burls. I think I just need the right build. I tried it again with the coil closer to the airhole, and the flavor is a bit better. I can't seem to get the wicking right. When I sub ohm it drys out if I chain vape, then I get that cotton-y juice flavor. It must be getting juice cause it uses it up like crazy.

[Kev]

Maybe a bad clone? On the aqua I can't go below .6.
If I do then it taste bad.

[E30_Pare]

i got a kayfun yesterday. Been trying to build it all day, but the flavor seems weak. I up the airflow and theres more vapor, but no flavor. I tighten up the draw, but the flavor isnt as strong as I expect. Tried micro coils, parallel, traditional, but nothing seems to work well. :(

[Kev]

When I got the igo-w the airflow was almost 0. Had to drill it out a bit. I will check though and see if wick is clogging it up.

I have been looking at mods the last few minutes and think I might order a Origin clone with a aqua rba. I have seen a few brands. Ehpro, Hcigar and Tobeco. I wonder which one is the one to go with.

I have a real kayfun lite and a kayfun lite clone by tobeco. Seems the quality of the tobeco clone isn't up to par so I might scratch that one off the list.

I have the Aqua for driving mainly or when I feel like not dripping.
Can lay on its side or upside down and it will not leak.
More vape then kayfun but little less flavor.
For the igo-w thats normal to have small holes but not good for vaping.
Mostly all atty needs to be drilled out.

For your burnt wierd taste, maybe its your first builds?

[E30_Pare]

typically hcigar makes better clones, but it really depends on what device. going have to research that one.

[campbellj25]

When I got the igo-w the airflow was almost 0. Had to drill it out a bit. I will check though and see if wick is clogging it up.

I have been looking at mods the last few minutes and think I might order a Origin clone with a aqua rba. I have seen a few brands. Ehpro, Hcigar and Tobeco. I wonder which one is the one to go with.

I have a real kayfun lite and a kayfun lite clone by tobeco. Seems the quality of the tobeco clone isn't up to par so I might scratch that one off the list.