Break into a snap on tool box. I cant seem to find the key anywhere and I really need to get into the box, I'd like to do it without hurting the box, but I dont care about the locks, those can be replaced...
-
Well Grab the lock cylinder with water pump pliers and turn it, only fucksitup a bit. -
9mm.
'nuff said.
If you care that much about the box, you can spend a few hours trying to figure it out.Originally posted by accident1990 300ZX TT 5spd ($6,000)Originally posted by kronus
1991 318i 4dr 5spd (DD)Comment
-
i had to cut a square in the back dead center. then you can lift the locking bar that holds all the draws shut, i had an old snap on box, i had to break into, if you do it clean you can also weld it back up when you get a key, good luck...Comment
-
If anyone else needs this, its really easy.
1: Call Snapon, say I need key for lock #XXXX
2: Pay 7 Dollars for Key
3: Open toolbox
4: ???????
5: PROFIT!Comment
-
Comment
Comment