Seat fitting issues - R3VLimited Forums

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

X

cganne

Advanced Member

Join Date: Jan 2010

Posts: 103
#1

Seat fitting issues

06-08-2010, 07:58 PM

Here is what I have:

Sparco Evo 2
Sparco Side Mounting Brackets
Sparco Sliders
Sparco Seat Bases

Just one question...WTF?? Nothing lines up with the holes on the base, is there a trick to this or do I need to fabricate something?
Tags: None
jlevie

R3V OG

Join Date: Nov 2006

Posts: 13530
#2

06-09-2010, 04:34 AM

You may have for make your own base or modify the Sparco base. The Evo 2 may be wider than what the base might was intended for.

The car makes it possible, but the driver makes it happen.
Jim Levie, Huntsville, AL
Comment
cganne

Advanced Member

Join Date: Jan 2010

Posts: 103
#3

06-09-2010, 05:05 AM

Am I ok to drill a new hole into the base? I'm just afraid it won't pass tech for NASA or SCCA if I do so.
Comment
idanity

Mod Crazy

Join Date: Jun 2006

Posts: 775
#4

06-09-2010, 05:51 AM

can you buy some blank steel and weld/ bolt in a connector ?

3 pedal club
200,k+ club
cabrio club
port-matched- polished- purring www.BMWpark.org

</div>

linux since 1999
Comment
cganne

Advanced Member

Join Date: Jan 2010

Posts: 103
#5

06-09-2010, 06:06 AM

I'll do whatever necessary, I just had concerns on passing tech.
Comment
jlevie

R3V OG

Join Date: Nov 2006

Posts: 13530
#6

06-09-2010, 06:28 AM

Yes, you can drill new holes in the base.

The car makes it possible, but the driver makes it happen.
Jim Levie, Huntsville, AL
Comment

Previous template Next

Working...