SoCal General Chat

[IRON-E]

It's my life, I live it the way I want.

Btw, the drive is on Sunday, will you be going Mike or you'll be out of town?

[mkcman17]

I'm gone sat afternoon through late monday :/

[Robert]

What up guys !

So today i was rear ended by my own brother ! :hitler:


My muffler is EXTREME DTM style now ! LMFAO ... -.-

[blackhawkimpact]

Doesn't look that bad

[Robert]

It's really not ..
The exhaust is done though .
But the dent under the light is probably going to cost the most to fix.

[blackhawkimpact]

Just fix it yourself? Hit the dent on the back with something?

[mkcman17]

That'll buff out.

[einstein57]

Just bought some powder coating equipment and a bunch of light green powder.lol

Also i'll take $300 for the exhaust. If you want it quieter buy a center muffler and i'll weld it in at no extra charge.

[blackhawkimpact]

May be a stupid question but do you remove the cat if you install a center muffler? I want to do just that to my exhaust setup.

[einstein57]

You have to run an aftermarket cat.

[blackhawkimpact]

After or before the center muffler? What aftermarket cat do you guys recommend?

[Robert]

Anyone selling an Ansa Sport Muffler , or Magnaflow 14815

[nickflic3]

lol @ r3v adds at the bottom of the page :rofl:

Dammit I want to cruise too! This car needs to run by Friday :hitler: Frikin fuel...

[supkev]

I got a magnaflow for sale but its not a 14815

[tonywonder]

so time is running out and i still need to do all my suspension shit. i bought extra parts (struts subframe trailingarms) to get all of this ready for an easier swap but i think im just going to stick with whats already on the car. i want this shit on and ready for bimmerfest.

anyways im replacing the front wheel bearings and i need to modify the front strut housings but im wondering if i should wait to put the new front bearings on til after getting the struts welded for the sleeves or if it doesnt really make much of a difference i can do it before hand then take it in to shorten the struts.

i figure labor costs would be less if all i have to get done is the shortening.

im figuring it wont make much of a difference but i just want to double check with those of you that have done this or have had this done. thanks dudes.