NorCal Chat Thread

[cyberkaa]

hmm. so what do you think i should do.

Ideally, you should replace the head gasket. Sealant is going to be a temporary fix.

[joonsup]

Btw, turns out that is a set of oil passages cast into the block and a leak from that location is somewhat common on older head gaskets.

hmm. so what do you think i should do.

[cyberkaa]

Btw, turns out that is a set of oil passages cast into the block and a leak from that location is somewhat common on older head gaskets.

[joonsup]

ok cool lemme know.

[cyberkaa]

kalim i cannot find online something similar to how your block was plugged to stop any leak. can you help? What do you think about jb weld

I'll see if I can find something similar. Definitely don't want to use JB Weld in that area.

[joonsup]

kalim i cannot find online something similar to how your block was plugged to stop any leak. can you help? What do you think about jb weld

[cyberkaa]

oh snap a norcal chat thread

Pretty crazy, huh.

[joonsup]

oh snap a norcal chat thread

[cyberkaa]

No posts in 4 days? This is nothing short of appalling. -____-

Anyway, finally done changing the motor out in this car.

[Danny]

wut

[cyberkaa]

Dead.

[cyberkaa]

Where's all the supposedly good California weather!?

[Cabriolet]

Crap that's far. I need some new bumper strips.

+1 i need a trunk lid

[Ian Bowers]

Crap that's far. I need some new bumper strips.

I can't remember, but I think the (rear) bumper strips were cracked. The bumpers themselves looked to be pretty damn good, though. I'm sure you could get one clean set.

[cyberkaa]

Windsor pick-n-pull has a bunch of AWII E30s in there, a few clean sets of plastic bumpers, as well as spoiler-less trunklids.

Crap that's far. I need some new bumper strips.