If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
how would you guys go about removing a snapped lug from a wheel adapter/spacer?
i overtorqued one by accident and need to remove the broken piece.
depends on how it is installed in the spacer/adapter. if its pressed in then its easy. if its threaded in them gonna be a PITA. take a pic of the backside of the spacer.
EDIT: nvm, i didnt read carefully, gonna have to use an extractor kit to get the broken piece out.
IG: @Baye30
FRONT VALENCE IS ZENDER!!! STOP FILLING MY PM BOX PPL!!!
From what I've heard it's extremely hard to remove...I was worried it'd take the paint off like Oliver said.
Also what do you guys use to paint these things? Plasti dip, SEM...?
it wont come off, its really really strong. if used properly its better than mechanical fasteners.
use plasti-dip, Sem is thinner and will show more of the imperfections.
i would probably straight trade my e30 for an e30 m3, but i would be taking a huge loss off the bat, which would make back its value over time due to the rarity of the m3...
which is why im constantly on the lookout for a good deal on a straight m3 roller, so i could just swap over all my shizz and be happyz.
IG: @Baye30
FRONT VALENCE IS ZENDER!!! STOP FILLING MY PM BOX PPL!!!
Comment