If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
How comfortable would you be in doing a set of 16" 5x120 to 4x100 RS's? I just picked them up and really don't want to get them back being able to see through the hub. Would I be able to send just the centers down or do you need the whole wheel?
How comfortable would you be in doing a set of 16" 5x120 to 4x100 RS's? I just picked them up and really don't want to get them back being able to see through the hub. Would I be able to send just the centers down or do you need the whole wheel?
You'd be able to send just the centers and, I'm very confident that, so long as these aren't porsche 16" wheels, I can take care of them.
Can you goes cut back rims to give them a different offset.
If a rim gives too much poke can you guys kinda cut it back?
It is possible, the issue is that some wheels are cut with just enough material to keep the lugs/studs secure. After shaving/milling you get into liabilities of wheel structure.
Comment