WS, NC meet!

[lordofmpower]

I am down biznitches

[SpecM]

SpecM...are you Simon?

-Haha no my name is Micah Braxton... sorry
-Some of you may know me from my AlpineWiese '88 2.7i. Stu, I know your dad helped me on the phone a couple times.

[Antrieb325]

I am down biznitches

Your Jay right? Figure out how far in/out the throw bearing needs to be in your tranny?

-Korey

[SpecM]

-Dang it, anyone here have a good-condition auto driveshaft they want to part with?

[sxecustoms]

im down for a meet...

[rThor432]

-Dang it, anyone here have a good-condition auto driveshaft they want to part with?

I do.

[rThor432]

Oh and a meet sounds great. Give me a little time though.. I need a radiator.

[Antrieb325]

How about June? That sounds like it would give everyone plenty of time to get their car's fixed. I know mine needs a lot of fixing (I need a diff if anyone has one.)
-Korey

[rThor432]

How about June? That sounds like it would give everyone plenty of time to get their car's fixed. I know mine needs a lot of fixing (I need a diff if anyone has one.)
-Korey

Ha yeah sounds about right. I need a diff too.. damn.

[Beauxsxm]

I'd deff be up for a meet. My work sched is usually hectic though so just let me know when and where and I'll see if it fits.
BTW: anyone in Greenville? I've seen some e30's around town.
Beaux

[Antrieb325]

rThor432, I guess we are stuck in the same boat.

[rThor432]

Ha yeah.. I just really want to drive the 325is to the meet. I could drive the auto-eta 4-door, but it just isnt exciting. I'm going to pick-n-pull tomorrow morning to check out a 535is.

Maybe I will get lucky with the pumpkin.

I have a tough life, but if the meet is in June, it should be no problem.

How far is Rural Hall from Charlotte? Any idea?

[Antrieb325]

1 hour usually, sometime 1.5 hrs depending on traffic. It's right beside Winston Salem. In fact my neighbor has a Winston address. haha

[T3HCH1LL5]

Hello antrieb how is the smurf.

[SpecM]

-Hmm yeah I've got a t-belt, tranny mounts, and rear wheel bearing to put in. And finish my shadowlining and I need a d-shaft. Lots of work. Lots of fun!