If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Made some progress on the track car. Gloss black 17x9" Apex Arc-8, APR front splitter, raised the rear wing 3".
I'd be curious to hear opinions on the front splitter. I either need to move the anchors up to the main bumper cover part so I can tie into metal or reinforce the lower section from behind. I'm not sure it will handle 100lbs of downforce.
It's a honey comb layers of carbon fiber. Def not willing to stand on it. Right now it's attached to the bottom of the front bumper cover. There is nothing solid down there to tie into but the plastic itself. I'm either going to fab a cross member or move the anchors higher or both.
Comment