FS: 17x8 ARC-8 Wheels (BBS reps, perfect offset)

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Roland H
    replied
    Originally posted by Bishop
    I'm fairly sure Lee's kit fits, but I could be wrong
    It does, and I classify brakes in the safety category of modifications. With your car, I'd do brakes, roll bar+seats, S50. And if you can come out ahead or about the same on a switch to 15inchers, do that too.


    In that order.

    I'd also go so far as to say that lee's kit would be capable of stopping an S50 equipped E30 on a track reliably with the proper pads.


    Remember, the 1995 M3 which came with the S50 only ran 235/40/17 tires in the rear. Obviously you'll need more because you don't have ASTZZZZZ and mad-tyte E36 rear-suspension shiznit, but a 245 should be plenty.

    Leave a comment:


  • Bishop
    replied
    Originally posted by clarkkey594
    David does make a very good point about not being able to upgrade your brakes for the 15's.
    I'm fairly sure Lee's kit fits, but I could be wrong
    Originally posted by Bimmerman325i
    Well, you can, you just run the possibility of needing to clearance your calipers. If you upgrade the motor beyond the normal S50 swap, you'd want larger diameter rotors than would fit under 15s......which is pretty much why the 17x8 Apex wheel exists. Wide tires + clearance for a 332mm BBK under stock fenders, it's kinda the raison d'etre.
    I can't argue here, you know this, and I've said this. IF I go s50, which it looks like I will eventually, then yes, I'd like larger wheels to put the power down, and definitely larger brakes to protect my investment.... However, on a stock m20, I don't really see the need for big brakes.. yet.

    Leave a comment:


  • Bishop
    replied
    Originally posted by Bimmerman325i
    Without taking a data logger to the track with a set of 15s and 17s with the same tire and just different sizes, you won't find any. Just people saying one is better than the other without any proof.

    A lot of guys in ST (spec civic) run 16s and 17s to get enough tire width. Tire width is most important, and a 15"/225 combo will weigh as near as makes no difference to your current package. Remember these wheels are LIGHT compared to 99% of other 17s that 'teh intarwebz' thinks are horrible.

    Also consider the cost- you currently pay more in tires, yes, but if you buy a set of 15s, and tires, you'll spend more money to get less tire..... You'd save a good bit of money just paying the extra $20-30/tire for the 17" wheel.

    Also, don't bother with R comps. You learn better and faster on street tires. Garrett's still running street tires, and is faster than many good drivers on R comps. I don't think you need to go to R comps anytime soon, or at least not until you can replicate that feat. Plus, you'll spend more money on R comps over time since you have to replace them much more often.
    New 15s plus tires would cost ~ what I'd sell the 17s for, so $$ is not really a factor there. R-comps, I've heard quite a few people telling me to get good on street tires, and I agree, but an r-comp on the smaller wheel is still cheaper than street tires on the larger wheel.... Smaller wheel would mean no more rubbing and feel a bit more nimble, plus the r-comps should in theory stick as well or better than the 17" street tires...
    Originally posted by Bimmerman325i
    1) 15" wheel is lighter, 15" wheel and tire package is not necessarily lighter
    2) that's a function of driver, not of wheels and tires. I boiled my brake fluid at Pueblo on 14s..... wheel diameter doesn't have any effect on brake boiling!

    15x8 will not give you a similar contact patch unless you can find a 235mm tire in 15" that fits under stock fenders.

    Plus, if/when you upgrade your brakes to a bbk, you'd need the bigger wheels.......
    There are 235/15s, why wouldn't they fit under the fenders? I know the selection isn't abundant, but in theory, why wouldn't they fit? As for brake fluid, I believe the 17s do require more stopping power. As for the BBK, Lee's kits fit under 15s.
    Originally posted by Bimmerman325i
    For DD, get a set of 15s or 16s and run crap tires. Hell, do it anyway to keep from burning through pricey fun rubber.

    For autocross and track, more contact patch directly translates to going faster with more control. There's a huge reason why Alex Schipkov runs 18x11s with 285/30/18 Hoosiers on his M20 powered DSP autocross car (~150whp).
    For DD I'm staying on caps. Alex can run 18s cause it's autocross. I understand the contact patch, but I'm trying to find the best compromise between grip, braking power / stress, cost, fitment, etc... Alex's brakes would die if he tried to stop those 18s at 120mph at HPR

    Leave a comment:


  • Bimmerman325i
    replied
    Well, you can, you just run the possibility of needing to clearance your calipers. If you upgrade the motor beyond the normal S50 swap, you'd want larger diameter rotors than would fit under 15s......which is pretty much why the 17x8 Apex wheel exists. Wide tires + clearance for a 332mm BBK under stock fenders, it's kinda the raison d'etre.

    Leave a comment:


  • clarkkey594
    replied
    David does make a very good point about not being able to upgrade your brakes for the 15's.

    Leave a comment:


  • Bimmerman325i
    replied
    For DD, get a set of 15s or 16s and run crap tires. Hell, do it anyway to keep from burning through pricey fun rubber.

    For autocross and track, more contact patch directly translates to going faster with more control. There's a huge reason why Alex Schipkov runs 18x11s with 285/30/18 Hoosiers on his M20 powered DSP autocross car (~150whp).

    Leave a comment:


  • Bimmerman325i
    replied
    Originally posted by iamcreepingdeath
    my only hard data that i can offer is this.

    1. 15s are lighter
    2. You boiled your brake (high performance) fluid on HPR, i didn't boil mine. (stock Autozone stuff)

    but 17s do give you a better contact patch, but a 15x8 arguably can give you a similar contact patch, but you will have taller sidewalls.
    1) 15" wheel is lighter, 15" wheel and tire package is not necessarily lighter
    2) that's a function of driver, not of wheels and tires. I boiled my brake fluid at Pueblo on 14s..... wheel diameter doesn't have any effect on brake boiling!

    15x8 will not give you a similar contact patch unless you can find a 235mm tire in 15" that fits under stock fenders.

    Plus, if/when you upgrade your brakes to a bbk, you'd need the bigger wheels.......

    Leave a comment:


  • Bimmerman325i
    replied
    Originally posted by Bishop
    We'll see... A lot of you guys push for 15s, which is cool, but I wanna see some hard data as to why 15s are better than 17s... I have my reasons to want to switch, but I do have a ton of grip with the 17s...
    Without taking a data logger to the track with a set of 15s and 17s with the same tire and just different sizes, you won't find any. Just people saying one is better than the other without any proof.

    A lot of guys in ST (spec civic) run 16s and 17s to get enough tire width. Tire width is most important, and a 15"/225 combo will weigh as near as makes no difference to your current package. Remember these wheels are LIGHT compared to 99% of other 17s that 'teh intarwebz' thinks are horrible.

    Also consider the cost- you currently pay more in tires, yes, but if you buy a set of 15s, and tires, you'll spend more money to get less tire..... You'd save a good bit of money just paying the extra $20-30/tire for the 17" wheel.

    Also, don't bother with R comps. You learn better and faster on street tires. Garrett's still running street tires, and is faster than many good drivers on R comps. I don't think you need to go to R comps anytime soon, or at least not until you can replicate that feat. Plus, you'll spend more money on R comps over time since you have to replace them much more often.

    Leave a comment:


  • iamsam
    replied
    Originally posted by Bishop
    We'll see... A lot of you guys push for 15s, which is cool, but I wanna see some hard data as to why 15s are better than 17s... I have my reasons to want to switch, but I do have a ton of grip with the 17s...
    my only hard data that i can offer is this.

    1. 15s are lighter
    2. You boiled your brake (high performance) fluid on HPR, i didn't boil mine. (stock Autozone stuff)

    but 17s do give you a better contact patch, but a 15x8 arguably can give you a similar contact patch, but you will have taller sidewalls.

    Leave a comment:


  • Bishop
    replied
    We'll see... A lot of you guys push for 15s, which is cool, but I wanna see some hard data as to why 15s are better than 17s... I have my reasons to want to switch, but I do have a ton of grip with the 17s...

    Leave a comment:


  • iamsam
    replied
    so you are officially not selling them now?

    Leave a comment:


  • Bishop
    replied
    More like: Selling the wheels, maybe not, end thread.

    Leave a comment:


  • Bimmerman325i
    replied
    Selling the wheels, not selling the wheels, selling the wheels, not selling the wheels... Dude... lol

    btw, good thinking.

    Leave a comment:


  • Bishop
    replied
    Yes, and pending some more thinking, these may be off the market...

    Leave a comment:


  • iamsam
    replied
    did you make a FS thread in the wheels for sale section?

    Leave a comment:

Working...