Anyone in Colorado have a SIR B-90 BMW Kit?

[Chrisbike]

Like the titles says; I'm looking for a SIR B90 BMW Kit to do my rear wheel bearings and axle R+R on my 91' 325iX. If anyone has one please let me know and we can get the ball rolling! I have all the hardware.. These things are crazy expensive to ship, almost to the point of making me rather buy one. PM me!

[Chrisbike]

Anyone got one?

[Chrisbike]

^

[Roland H]

I typically just use le harbor freight press.

[Chrisbike]

I typically just use le harbor freight press.

Which one? I might go that route.. Isn't it the front bearings kit?

[Roland H]

This bad boy.

http://www.harborfreight.com/20-ton-...ess-32879.html

Front bearing kit may work though. You just need something big enough to support the outer race when you're pressing the new one in so you don't destroy the bearing, but not too big or else it won't fit in the "cavity"

[Roland H]

I've broken B-90 tools before. Never had an issue with a press.

[Chrisbike]

Wait so are you removing the whole control arm to press the new bearing in? Do I still need a bearing separater and puller? I'm not educated on bearing jobs with presses. I've only reviewed the DIY's where people use a puller with different size Mandrels to remove the outer race and install the new bearing and a bearing seperater to remove the inner race from the hub.

[Roland H]

slidehammer usually works well for those. I usually borrow that and the wheel bearing kit from autozone. then use the press to press the new bearing in

[Chrisbike]

I'll look into this more and pm you. Thanks for the help!

[lambo]

I have this kit from Harbor Freight. Used it a few times. Works quite well. You're welcome to borrow it if you need it.

http://www.harborfreight.com/fwd-fro...ers-66829.html