WTB 84 or 85 eta wiring harness and getrag 260

[jeffw]

I am swapping the m10 to an m20 and need the getrag 260, throw out bearing, pressure plate, clutch, single mass flywheel and the eta wiring harness. Not the round one either the little flat one thats plug and play on the 84 318i. Need it SOON guys. let me know

[dashboardmonkey]

I need a harness too :(

[Schniddy]

Little flat one?
I have a 84 eta harness minus the separate window harness.
I don't think its perfect though.
I can take it out and snap pics for..ehh $25 shipped

[Schniddy]

If your looking for an ETA throw out bearing, pressure plate, and clutch I have that. Not sure about a single mass flywheel. Around 30-40k on everything.

[dashboardmonkey]

yes that

jeff is my buddy here so I know what is needed

those prices sound ok too

[jeffw]

lol good looking out dick. that stuff does sound good though.

[Schniddy]

$75 shipped for all of it
Will need time to remove everything

[jeffw]

its not the tranny just the other stuff?

[jeffw]

changing to an I swap no eta for me. still have to use the early eta wiring harness though for the flat plug

[red911turbo]

I have a 260 trans, I'm just up in Salem! Let me know.

Cheers,
Chris

[gregslow318i]

if you need I can build you an adapter that goes from the early c101 plug to the late (I) plug so you can use a later model harness

http://www.munichautosports.com/Adapter%20Types.html

would be a type 2 adapter see site above