WTB; M20 pressure plate bolts

[Savagefurai]

Hey there,
Seems that the PO strijpped the bolts out and now they're f**ked.
Need a set or at least three good ones.
For an m20B27

Thanks dudes.

[Wishno87]

I probably have some around. They hex heads or torx?

[LuckyHenriksen]

Shouldn't this be something to buy new?

[Wishno87]

Shouldn't this be something to buy new?

Ya I think it is one of the bolts you are supposed to buy new. But if your in a pinch I don't think a Seta is going to blow off some used pressure plate bolts.

[LuckyHenriksen]

Haha I would be more worried about easily stripping them

[DrJosh]

I got mine at the dealer. They had them in stock and weren't very expensive. This was after trying to use old ones and stripped them.

[Jafxod]

Anyone know the torque spec on these?

[Matt-B]

yea as tight as you can make it with your hand

[brutus87]

With greasy fingers.

[brutus87]

Or check the bentley.

[DrJosh]

Pressure plate bolts

torque grade 8.8 bolts to 18 ft lbs and grade 10.9 bolts to 26 ft lbs. It will say the grade of the bolt on the head. Also, remember to do the start pattern deal. Also go back over all your "tighten" ones to make sure they are still torqued properly.