I've got an M20B27 Head that is ready for a new home. It's getting swapped out for an 885 head. No problems at all and I just spent a few hours cleaning it up this morning. Comes with the valve cover.
You're welcome to install it as it. IMO the right thing to do would be to at least through a new Valve Cover gasket, and rubber end plugs at the same time.
100.00 OBO picked up in Seattle. I JUST drove a car powered by this engine less than a month ago, I also believe the valves were adjusted by the PO not too long ago. I would feel confident dropping this into an Eta just for a "refresh". Good time to add a painted Valve Cover and Intake Manifold to the mix.
Thanks for your time guys,
Paolo
You're welcome to install it as it. IMO the right thing to do would be to at least through a new Valve Cover gasket, and rubber end plugs at the same time.
100.00 OBO picked up in Seattle. I JUST drove a car powered by this engine less than a month ago, I also believe the valves were adjusted by the PO not too long ago. I would feel confident dropping this into an Eta just for a "refresh". Good time to add a painted Valve Cover and Intake Manifold to the mix.
Thanks for your time guys,
Paolo
Comment