guys on this forum rock!!

[tyeetoo]

Road warrior yesterday. 700 miles rt in 12 hrs! Just put the Dodge cummins on cruise and let er rip. When I arrived Dan and his dad were there to load the low milage M-42 into my pu. His dad is a retired euro mechanic and said that the engine ran very well and is a strong runner. I'm excited to start the resto process. Came with tranny and all electronics. Will post pic when the I get the engine in my shop. Hope to have it all together in next few months. You guys have been great and I'm sure I will have a ton of questions as I proceed. thanks again, m

[eur04lif3]

is this the old man from mapleton? lol

Congrats on the new motor. So a swap thread soon?

[shameson]

I've found all the answers to my questions through this forum. And also a lot of parts I needed. Met some pretty cool and helpful people too. IMO it's the best car forum I've seen

[Savagefurai]

Agreed.
Not only have i found all the info i have needed so far on this forum but i have managed to make quite a few new friends.
People are quick to help in an emergency and i even had a dude order me a keychain just cuz i was down on my luck for a while.
Top notch!:D

Sent from the Moon using Tapatalk 2

[HarukoE30]

Road warrior yesterday. 700 miles rt in 12 hrs! Just put the Dodge cummins on cruise and let er rip. When I arrived Dan and his dad were there to load the low milage M-42 into my pu. His dad is a retired euro mechanic and said that the engine ran very well and is a strong runner. I'm excited to start the resto process. Came with tranny and all electronics. Will post pic when the I get the engine in my shop. Hope to have it all together in next few months. You guys have been great and I'm sure I will have a ton of questions as I proceed. thanks again, m

This swap is happening after the BBQ? You gotta come out to the BBQ

[tyeetoo]

bbq

when and where is the bbq? I'd like to make it. thanks, the old man from Mapleton. lol. mike

[Keith M]

There is a stickied post that gives all the details on the BBQ. I would enjoy seeing an example of what our cars looked like when they rolled off the assemble line. Hope you can make it Mike.