FS Eaton M90 supercharger

[JJe30]

I acquired this in a trade. I never used it. I was told the bearings were all replaced and have 0 miles on them, the rest has 2k miles on it. It supposedly has a Corrado pulley on it. I'm asking $250 obo, I could ship if buyer wants to pay for shipping it.

[JJe30]

Bump

[kylelauffer]

any ideas were to get the intake manifold to bolt this on to a bmw? is this off a mustang?

[iansane]

any ideas were to get the intake manifold to bolt this on to a bmw? is this off a mustang?

Looks like a GM part number. Front wheel drive 3.8 buick?

[JJe30]

I'm not sure what it came off or or where to get a manifold for it.

[Rennsport]

These came on the Pontiac Grand Prix and if I'm not mistaken the Buick LeSabre

[Ether-D]

Grand prix & bonneville for sure.

[e30austin]

Have fun fitting that on a BMW.

[slammin.e28]

Have to have a little fun making it fit, but it is possible.

[RickSloan]

M90s are tough to fit because the nose cone is so long. The m62 fits just right tho. Plates will be available for the m62 in the very near future. Check the forced induction section.

If the thing is rebuilt, $250 is a decent number, but that pulley looks stock. these things are a ton of fun in an e30, so hopefully somebody picks this up!

[JJe30]

I had contemplated trying to get it to work on my 535i, but I would rather put the funds to my e30