Exhaust shop recommendation? [North of Dallas]

[chopper731]

I've got a Magnaflow 14816 I want to get put on my 325is. It has got a single 2.25" inlet and going to require some fabrication of a y-pipe.

I think a competent exhaust shop should be able to do that part but I was also wanting to get rid of the cat and just run piping from the down pipes back to the muffler and getting a shop to do that is a different story. Any shop recommendations or suggestions in the Dallas area (I'm in Mckinney)?? I'm usually a diyer but sadly can't fabricate/weld.

[CB-M3]

B&B Muffler off 35 near Carrollton. Cheapest prices around. They cut out and welded in new magnaflow cat (provided) for $60. Did it in 30min.

[Bimmerista]

Bobby Gentry Muffler in Denton is a shop I've dealt with in the past, they were reasonable in price & service.

I've also dealt with B&B Muffler in Carrollton and they're pretty good too.

[chopper731]

Thanks for the recommendations, I appreciate it.

[Vtec?lol]

If you can't find anyone I wouldn't mind helping you.