User Profile

[The_Glory]

Disassembly of the BOSCH BEHR R12 air conditioning compressor (training)

Finally, it came to the last element of the air conditioning system - the compressor.
I have three of them....

[The_Glory]

Emergency flashlight

I have written about this emergency flashlight before - then I just cleaned it and put it away. Finally, it was time to make it fully functional. I bought batteries....

[The_Glory]

Assembly_200. ETK_01_Technical Literature

So, this is the 200th, "anniversary", entry on the assembly of my E30, according to the ETK sections. Externally, the car is fully assembled,...

[The_Glory]

So that's not the problem.
Maybe I'm not understanding something correctly, or I'm not measuring it correctly, but it seems to me that that magnetic contact works like a rheostat. That is, it doesn't...

[The_Glory]

Yes, I know, thanks. I already bought a lock from an E36 and tried to disassemble it to rearrange the lock contact from it. But it turned out that there, as on all subsequent models that have pre-tensioning...

[The_Glory]

Assembly_199. ETK_51_License plate mounting

Bumpers installed, now I can install license plates.
The front license plate mounting is not indicated in the ETK for some reason. But, judging...

[The_Glory]

Assembly_198. ETK_51_Rear bumper (part 2)

So, let's start installing the rear bumper. To do this, you need to remove the rear panel trim in the trunk. Also, for convenience, it is better...

[The_Glory]

Assembly_198. ETK_51_Rear bumper (part 1)

Installing the rear bumper.

Rear bumper




Part #1 - middle rear bumper (51 12 1 888 276) - standard...

[The_Glory]

Assembly_197. ETK_51_Front bumper (part 2)

So, let's start installing the front bumper.

Connect the connectors of the front turn signals and check if they work properly. It's...

[The_Glory]

Assembly_197. ETK_51_Front bumper (part 1)

Finally, it's time to install the bumpers. I'll start with the front one.

Front bumper




Part #1 -...

[The_Glory]

Thanks, I think it will look good!
I tried to prevent future corrosion as much as possible. Hopefully this will work....