User Profile

[s14brent]

lol, it's my own fault. I actually enjoy upgrading the garage a bit too much apparently. I ordered 4" 1400lb locking/swivel casters for the main work bench and plan to use the old ones on my toolbox...

[s14brent]

so this threw me down a rabbit hole I wasn't expecting to go on......I ended up doing some upgrades on it today because I got bored and watched some of the YT videos I mentioned above. I actually had...

[s14brent]

well my HF table measured in at 8 gauge (0.1644) steel (i'm seeing harbor freight lists it as 6 gauge which it definitely isn't), and beefcake is 1/4" thick and has some crazy send-cut-send architecture...

[s14brent]

Thanks! I'm quite pleased with how it turned out!



The old setup always got cluttered with junk. Having the smaller table will hopefully stop me from doing that *fingers crossed*...

[s14brent]

Thank you sir! I'm hoping this doesn't take too much longer.....



I did the pan for "D) all of the above". I got used to overfilling to the top line for track events...