Originally posted by bme30
View Post
Announcement
Collapse
No announcement yet.
Which Tie Rod Puller?
Collapse
X
-
Well, all of these tools/videos, etc, show just removing the tie rods and I didn't have any trouble removing those from the spindle....it's the control arm ball joint that I can't get to budge....I'm going to buy a small sledge and git it a couple whacks, but I'm doubtful it will work.1997 Artic Silver M3
CES GT4094r 651hp/615tq @ 24 psi
Comment
-
Originally posted by iamcreepingdeath View Post^^ that's BS. I do that every time, and it is not that easy.
Comment
-
Originally posted by Alexis Jung View PostWell, all of these tools/videos, etc, show just removing the tie rods and I didn't have any trouble removing those from the spindle....it's the control arm ball joint that I can't get to budge....I'm going to buy a small sledge and git it a couple whacks, but I'm doubtful it will work.
PS: Do not hit the "male" part of the joint, hit the "female" part of the knuckle arm.
Comment
-
Get this kit and you will not have problems with pretty much any front end work; especially on most Euro cars...
You can score the kit for less than a $100 if you watch for deals and promo's.
We've used my set on over a dozen front end rebuilds on BMWs, a couple Volvos and two LR Disco steering linkage rebuilds. Great kit and very versatile.
Comment
-
I use an 8lb Jackson sledge and pickle fork but majority of the time I don't even need the fork. just compress the strut by placing a jack underneath the spindle. loosen the fastening nut and hammer on the stud. should break loose and you can pull it out by hand. don't worry about mangling the nut as you're suppose to replace it everytime the tie rod comes off. I've never ripped a boot that wasn't already ripped.
Originally posted by Ryan...It now emits a beautiful blue-ish yellow/green smoke from the exhaust?? No idea what would cause that color, but I assume its good.
Comment
-
I want to thank you all and advise others that ALL YOU NEED IS A 4 LB HAMMER TO DO THE JOB!!! The ball joint fell out on its own within 4 - 5 good hits....not even full swings, just contact. I'm going to return the $70 set to harbor freight that I bought.
Now, to get the threaded collar off the strut and get my passenger side tie rod off..1997 Artic Silver M3
CES GT4094r 651hp/615tq @ 24 psi
Comment
-
Originally posted by immajackuup View Post
Comment
Comment