So I have a custom exhaust with a Borla center muffler and a rear Magnaflow, all with 2.5" piping. It sounds great!!
It all hangs nicely except for the Magnaflow at the very back...
I have an exhaust hanger that bolts to the rear subframe to locate the exhaust where it crosses under the subframe.
How is anyone hanging their muffler, without using the rubber donuts?
I tried using the rubber donut mounting points but the muffler swung around too much because it was shorter than stock so could only use one donut.
I'd like to weld something right above the tail pipe and then ...?
Ideas??
It all hangs nicely except for the Magnaflow at the very back...
I have an exhaust hanger that bolts to the rear subframe to locate the exhaust where it crosses under the subframe.
How is anyone hanging their muffler, without using the rubber donuts?
I tried using the rubber donut mounting points but the muffler swung around too much because it was shorter than stock so could only use one donut.
I'd like to weld something right above the tail pipe and then ...?
Ideas??
Comment