So as of right now i have an already swapped E30 M3 with an OBD1 S52 that wont run properly after months of trying to fix it. browsing through the S54 swap guides it seems like the two are pretty similar as far as swap work goes but r3v gurus know best so i want to figure out what the actual rest of the swap would entail
here's essentially what i confirmed from my research that would be required:
-source engine/harness/ecu
---includes tune and engine wiring harness work
-install drive by wire throttle
-if desired install sport button
-arc asylum work on oil pan and subframe
some things i THINK work as is but unsure of 100%:
-same engine mounts?
-same 5-speed? and clutch/flywheel?
-same exhaust even??
im sure i missed some as its been a minute since i last went through but if as much stuff carries over as i think that would be incredible. i just want to figure out all the ins and outs beforehand and im sure at least one person has done this or researched this before.
here's essentially what i confirmed from my research that would be required:
-source engine/harness/ecu
---includes tune and engine wiring harness work
-install drive by wire throttle
-if desired install sport button
-arc asylum work on oil pan and subframe
some things i THINK work as is but unsure of 100%:
-same engine mounts?
-same 5-speed? and clutch/flywheel?
-same exhaust even??
im sure i missed some as its been a minute since i last went through but if as much stuff carries over as i think that would be incredible. i just want to figure out all the ins and outs beforehand and im sure at least one person has done this or researched this before.
Comment