Think about replacing the chain guides, along with the rear and front crank seals. I went ahead and replaced EVERY seal when I rebuilt mine. So much easier when it's out. Especially the rear main....
Announcement
Collapse
No announcement yet.
Matracer's project: BRONZIT S52 - DYNO RESULTS P.8
Collapse
X
-
Originally posted by MatRacer View PostDid 8 valve seals tonight. They are a pain to remove!
Dropped one retainer lock in an oil return conduit[emoji35]
But I have a magnetic oil drain plug!!
Pretty lucky!! Haha!Simon
Current Cars:
-1999 996.1 911 4/98 3.8L 6-Speed, 21st Century Beetle
Make R3V Great Again -2020
Comment
-
finally reassembled the cams after doing all 24 valves seals. timed the cams. while there, checked the actuation of the vanos with air. My regulator was set at 60psi. The vanos was doing its job, but the vanos structure or frame or call it as you wish is flexing enough for me to notice it when actuating the vanos solenoid! Is this normal?E30 now S52
2008 Suburban LTZ (Family and TT hauler)
325xiT (Sold)
sigpic
Comment
-
Concluded that it should be fine. Everything works properly and the force needed to actuate the vanos should be less with engine running and we'll lubricated. Engine finally fully sealed! Also, installed new exhaust studs and OBD1 vanos solenoid for its long wire, OBD1 knock and cam sensors. OBD1 valve cover is also on.
Last edited by MatRacer; 04-27-2016, 12:18 PM.E30 now S52
2008 Suburban LTZ (Family and TT hauler)
325xiT (Sold)
sigpic
Comment
-
So engine is In! The S52 will be driven on OBD1. I know that OBD1 is dumb compared to OBD2, but since I had all the required stuff for OBD1 and not for OBD2, I went with OBD1...
Here is all the OBD1 stuff that I needed:
Intake, throttle body and related sensors
Cam sensor
crank sensor
Knock sensors (don't know if really required but had them so...)
collant hose with timing chain cover adapter tube
head cover and coils to run the OBD1 oil vapor stuff
vanos solenoid for its long wire
DME engine temp sender
all the wiring
413 DME with TMS chip
Kept my S50 oil filter housing (because its polished!) so don't really know it I would have needed to change the oil pressure switch... I guest yes...
Since I have a VDO coolant temp gauge with a sender adapted for the throttle heating port o nthe head, I need to find a way to add the cluster temp gauge sender... Will do this later.
Should be cranking it soon!!!E30 now S52
2008 Suburban LTZ (Family and TT hauler)
325xiT (Sold)
sigpic
Comment
-
It's running!! And pretty good... it hadn't ran for 3 years and the lifters were discharged... sounded like a diesel for like 5-10 min and then everything went just fine
I really like how it sounds! Will video it soon and share it!!E30 now S52
2008 Suburban LTZ (Family and TT hauler)
325xiT (Sold)
sigpic
Comment
Comment