If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
anyone care to help me i.d this turbo? I was told its a holset h1c turbine mounted to an hx60 compressor. Im fairly certain based on research that this is correct, I did notice though that there is no pressure nipple on the compressor, its on the wastegate?
Hello, Looks like a HX35/WH1C turbine housing (probably 12cm2), WH1C/H1C center section, no way of telling on the compressor wheel size without measurements or pictures. Doubt that is a a HX60, maybe a 60mm wheel however. Hope this helps.
The OE application did not call for it. If I was guessing, this is a turbo assembled from at least two units, the original turbo that the compressor housing came from more than likely did not have a wastegate actuator.
Comment