Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
A few thoughts. First, the vent sliders have to be in a specific position for power to go toward the compressor. The slider contacts can be dirty. When I had my dash apart I bypassed that switch. ...
-
High & Low beam bulb with integrated turn signal?
I would like to eliminate the turn signal from front diving board bumper. A year or so ago I saw a picture with the turn signal removed and it really cleaned up the front bumper. The question that I...
-
Did you replace / resurface the flywheel? Is the tang still there that the reference sensor uses? If new flywheel, is it the right one with the tang? When you replaced the reference and speed sensors,...
Leave a comment:
-
First, check the rotor, it is difficult, but not impossible to put it on wrong. Check you have the spark plug wires going to the correct spark plug. Is the crank position sensor connected and installed...
Leave a comment:
No activity results to display
Show More
Leave a comment: