I need to replace them, I have the parts, but no money, and a mechanic told me I needed a press to do it, is that true? or can I just do this in the Garage at home?
Announcement
Collapse
No announcement yet.
flex disc/drive shaft bearing question.
Collapse
X
-
Good call. I have never replaced that bushing actually. A little silicone grease has always been needed to make it slide onto the output shaft properly though.
One more note: The center support bearing can be a pain in the ass to get off of the driveshaft. You do NOT need a press, but it can take a good amount of fiddling with a big screwdriver, or in extreme cases some very careful work with a Dremel to slit the sleeve that fits tightly on there.
Comment
Comment