Hello R3V, I'd figured I'd post my question here after getting mixed answers on other forums.
I'm in the process of replacing my friends cylinder head on his 328i E36 and I've got the head on and following the procedure of the torque pattern, I torque'd the head to 20lb's and then 45lb's, can I go ahead and set my torque wrench to the final torque and finish the headbolts? Or have I done this all wrong because I'm not using the 90 degree trick.
Basically what I'm asking is, what should the final torque be on 24v headbolts, and can I finish the job without the 90degree angle trick?
I'm in the process of replacing my friends cylinder head on his 328i E36 and I've got the head on and following the procedure of the torque pattern, I torque'd the head to 20lb's and then 45lb's, can I go ahead and set my torque wrench to the final torque and finish the headbolts? Or have I done this all wrong because I'm not using the 90 degree trick.
Basically what I'm asking is, what should the final torque be on 24v headbolts, and can I finish the job without the 90degree angle trick?
Comment