Yay valvetrain failure.

[AwakenNoMore]

Nice.

Niiiiice.

Lapped.



Also this: I've always wanted to do sharkface E30, when I saw it on epiphy's baja project car I was sold. So I got bored and played with silver sharpie and drew up a rough draft.

Was thinking about getting personalized plates that say TNKBSTR for the A10 Warthog.

[EatsHondas]

I'm in the middle of the exact same disaster and rebuild. Lapping the exhausts now, then going to start putting it all back together. Keep the photos coming man, they look great.

[AwakenNoMore]

[CabbE30]

^Are you resting the head on the valves???

[EatsHondas]

^Are you resting the head on the valves???

#1's valves are off the table, he's probably got it rotated so none are touching.

[AwakenNoMore]

#1's valves are off the table, he's probably got it rotated so none are touching.

This.

[AwakenNoMore]

[AwakenNoMore]

this pitting in the gasket surface, do I have to worry about it?

[AwakenNoMore]

screw it, throwing it together. swabbed and tapped head bolt holes TWICE, cleaned top of block with brake cleaner then alcohol and dropped the gasket on. Everybody loves a little GOATZE.

[AwakenNoMore]

Tits.

[digger]

screw it, throwing it together. swabbed and tapped head bolt holes TWICE, cleaned top of block with brake cleaner then alcohol and dropped the gasket on. Everybody loves a little GOATZE.

goetze porn ftw

[AwakenNoMore]

almost done

[EatsHondas]

Very nice work. I am all too familiar with this annoying/expensive/time-consuming job. It came out perfect for me though, should be the same for you.

[Tisoc]

How did you clean the block surface? Looks supah clean

[offsetmotorwerks]

Great build :) Cant wait to see the video of it running. Took a second glance at the shark face.... loving it haha.