So i burned out my rear sub frame bushings in prep to put in some new condors. However it looks like there is a sleeve or something else in there making the hole not circular but more elliptical and the condors dont fit at all. There are some flange looking bits on both sides but i wanted to double check before i take a hammer to them.
Any input would be fantastic.
Iv outlined the flange bits im talking about. (looking at the pic now i may have been an idiot and just now answered my own question)
http://i.imgur.com/SaIT60z.jpg
Any input would be fantastic.
Iv outlined the flange bits im talking about. (looking at the pic now i may have been an idiot and just now answered my own question)
http://i.imgur.com/SaIT60z.jpg
Comment