M20 turbo manifolds

[fastboy559]

Gauging interests in some m20 turbo manifolds... Nice ones not junk!! I am starting my own business and looking to if there would be any interest in a nice schedule 10 manifold completely ported and can be custom built
If you want to check out my work you can see at Spiessfabrications on Facebook and my Instagram is isaac559 ... I have almost 10 years in the industry and my work is high quality ...

[gotaloveRWD]

It all comes down to price after quality
Everyone wants one but most people don't want to shell out more then 1000 bucks

[kistler#7]

If you offered twinscroll for under a 750 to a grand I bet a lot of people would be all over it
A lot of people just want a decent standard t3 or t4 manifold though. Blunttech has the m5x and m30 motors covered but for m20 there's not a whole lot between cxracing and AR designs

[fastboy559]

Yes I will offer a twin scroll but it will be more money... It is more work and material ... My manifolds are top quality fully back purged and ported

[fastboy559]

Some evo x manifolds I've done

[nomansland92]

Id be interested in t3 manifold to fit an ix

[MR 325]

I'm sure the interest is there. Your work looks good.

You're not going to find any committed buyers without a sample manifold done and set pricing though.

[318aye]

There's definitely been a market void as of late. I'd definitely be interested in seeing your sample. I'd buy a 666 or Revshift if either were readily available. 750-800 for a full 6-1 manifold with 38mm MV-S provision would certainly do the trick for me.

[Hoffbrohaus]

see if you can partner with KA motors and supply your manifold with his Turbo kit.

[fastboy559]

That might be a possibility ... Might do my own kit... I'm pretty particular so might do my own kit setup for borgwarner turbo

[gotaloveRWD]

looks like you do great work
I'd be interested since what's been holding me back from a turbo build is a quality manifold at a price that doesn't feel like I'm being raped

[fastboy559]

Ok.... There is alit if work that goes into a quality manifold... And. Manifold that is built rite should last a lifetime

[fastboy559]

I'll be trying to get pricing for the materials this week and hopefully start one in the next month and then set I final price

[DirtyMaxTJ]

I'm definitely interested. The build quality looks awesome but the price would be a big deciding factor for me and many others.

[IronFreak]

I laughed so hard I pooped a little.....quality twins scrolls for under a grand, please....do share what you're smoking. If people think that $1500 is to much for this type of work you have ABSOLUTELY NO IDEA the amount of skill, effort equipment and consumable cost that goes into making something like this.

End rant-

Yours Truly,

Fellow Fabricator.

(When your hood drops the bullshit stops, rock on brotha)