2 E30 ITS/KP/GTS race cars for sale

[gobuffs]

I have not one, but 2 E30 race cars for sale. Both are the same except for the vinyl wraps. Both are built to SCCA ITS specs (can be run in BMW club in the KP class or in NASA GTS- guessing GTS2 or maybe GTS1). Both were finished out by Bimmerworld. They have Stack dashes, wired for radios, etc etc etc. I was told they are built to the limits of ITS specs. I was also told they are putting out ~160 RWHP. Each car come with one extra set of rims. Both are covered in vinyls wraps and are white under the vinyl. Located in Tyler, TX (about 2 hours east of Dallas). I can arrange a test weekend for potential purchasers on a mutually agreeable weekend at Eagle's Canyon Raceway in Slidell, TX (NW of Dallas)- nonrefundable deposit required. $20k each.

[hugh jass]

you might want to provide a little more detail on the cars if you are asking 20k each

[gobuffs]

I just got em Saturday. Trying to figure out what is there.

[bmw325csi]

they look pretty cool, but what is the rattle canned floor hiding? Rust i'm assuming (I know, assumptions are dangerous) and was it really necessary to paint the brake and clutch pedals? Also what suspension are they running?

[gobuffs]

I need to get them up on the lift this week and check. Don't think I would assume rust. Appears all compartnments were painted prior to assembly. And, yes, it wouldn't have been too hard to remove the rubber pedal covers before painting!

[sharky]

Ha, lol at 20K each.

[gobuffs]

Ha, lol at 20K each.

Did I ask for a comment on asking price?

[Jon325i]

Ha, lol at 20K each.

Can you replacate one for less? They look like well prep'd cars to me.

Definately post more info on them when you can. Good luck :-D

Jon

[gobuffs]

Can you replacate one for less? They look like well prep'd cars to me.

Definately post more info on them when you can. Good luck :-D

Jon

Thanks. your reply is better than mine. I'll remember that for next time. :-)

I'll get them up on the lift this week, but it might be later in the week.

[gobuffs]

Got under the Funtime car tonight...here's what I found.

Car was started to be built by Bobby Bitterman in Birmingham, AL, but was finished by Bimmerworld. Engine was supposedly built to ITS spec limits and I was told puts out 162 RWHP.

Oil cooler
yellow engine mounts (brand?)
new-ish looking radiator and alternator
Stahl headers
straight pipes (side exhaust)
new-ish looking guibo
new-ish not stock plug wires
adjustable FPR
engine hour meter (3.7 hours running time since engine rebuild)

brake ducts with backing plates
RD front sway bar
no rear bar
Koni DA coilovers...unknown spring rates (I might have them in some setup sheets.
SS brake lines
Appears to have E30 M3 offset CABs
trailing arm bushings look new-ish but unknown what they are
Powerflex rear subframe bushings
brake discs appear new-ish
front strut brace

Recaro Pole Position seat (date 8/05)
G force belts (good thru '11)
G froce side net (date 8/06)
Team tech center net (unknown date)
Longacre quick disconnect steering wheel
brake bias adjuster
wired for radio
Fire extinguisher
Optima red top battery

some rust in the driver floor board. isn't too bad, but might want to be addressed
front subframe has NOT been reinforced
AMB transponder
battery kill switch
STACK dash

Again, I have the SCCA and BMW CCA log books.

[gobuffs]

gotta go ASAP...$20k for both!

[318kid]

Slidell you say? I live in Bolivar... I wana come some them... but I dont have any money... Look like nice rides though.

[Nicademus]

That Funtime Ice one is on eBay.

[gobuffs]

These gotta go....now on Ebay. Both cars will go for the 12.5k bid. 2 cars for $6250 each? The STACK and Koni DAs are worht just about that alone.

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MESELX:IT&item=150284161060