FS: Comlpete early e30 Zender body kit

[grey ghost]

I have a complete kit in good condition except for one side skirt that is cracked but repairable.

I have:
Zender Front spoiler - its a little twisted but only takes one finger to twist back and once mounted it will sit right.
$130.00



Zender Rear valance - this rear valance is the three piece unit.
$130.00



Zender deck wing. the deck wing is in good condition and all the mounting points are still intact.
$100.00



Kamei side skirts - one side skirt has a very long crack as illustrated but it can be repaired using fiberglass, sand, paint and it will be like new.
$40.00

All parts will need sanding and painting as you can see the paint chipping off.
I would like to sell the kit complete.

[grey ghost]

Revised pricing.

[coreyw]

Do you know if the rear apron fits euro bumpers?

[grey ghost]

Do you know if the rear apron fits euro bumpers?

I do not. I know someone here does though.

[JasonC]

I do not. I know someone here does though.

It doesnt. The one for euro bumpers dont have the cut out for the exhaust, but has a cut out for the tow hook.

[Jrey]

It doesnt. The one for euro bumpers dont have the cut out for the exhaust, but has a cut out for the tow hook.

Little off topic but I have a zender kit myself and I got a euro eta, is it possible for the one that does have a cutout for the exhaust fit onto my eta?

Sent from my X10 using Tapatalk

[grey ghost]

Little off topic but I have a zender kit myself and I got a euro eta, is it possible for the one that does have a cutout for the exhaust fit onto my eta?

Sent from my X10 using Tapatalk

Thanks.
I figured it could work.
I couldn't see how it could be so dramatically different that it wouldn't work with a little work.

[Jrey]

Thanks.
I figured it could work.
I couldn't see how it could be so dramatically different that it wouldn't work with a little work.

To be honest, I highly doubt they have different mounting points, yet I wouldnt be sure because Zenders are rare AFIAK, it's not like I can go to an e30 meet and try their rear valance, I'd have to be lucky to know someone that has one or there's one at the meet that's selling it

Sent from my X10 using Tapatalk

[coreyw]

The front spoiler looks like it was off a euro bumpered car, but the rear doesn't. You don't know what car these originally came off of?

[grey ghost]

They came off a US bumper'd car. The way the front and rear were attached lead me to believe that these were for a euro car.
The front bumper was only attached in the fender arch, two screws on each side.
The rear bumper had two screws in each fender arch and one going thru the bumper trim into the screw hole the secures the valance corners to the center section.
Installation on the front and rear was incomplete and the rear didn't make sense.
The installation job was not great, but the pieces are in very good condition other than paint.

[coreyw]

After some research (finding much about Zender and e30s is pretty hard), I'm almost sure the front was originally made for euro bumpers.
And the rear for US metal bumpers, as this is what the euro bumper version looks like.

Here's a bump for you though.

[grey ghost]

Bump

[JasonC]

After some research (finding much about Zender and e30s is pretty hard), I'm almost sure the front was originally made for euro bumpers.
And the rear for US metal bumpers, as this is what the euro bumper version looks like.

Here's a bump for you though.

That one is for plastic bumpers.

[grey ghost]

1st $300 takes it all....
Shipping is extra....
Will deliver for a fee within 100 miles......

[grey ghost]

Sold