Delrin Carrier Shifter Bushings $15 shipped

Collapse
X
Collapse
 
  • Page of 12
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 4 5 12 template Next
  • garagistic
    Forum Sponsor
    • Apr 2011
    • 1712
    #16
    Originally posted by ballski
    average install time?

    Depends on couple of things actually. Trans in the car, out of the car, installing a short shifter while your at it? Exhaust clearance?

    Assume 2-4 hours. (mostly getting to it).

      Comment

      • SoCalKidz
        Wrencher
        • Jun 2011
        • 244
        #17
        Tips on the best way to install it? Trans in car no short shifter.

          Comment

          • Vivek
            attention whore/retard/bitch
            • Oct 2011
            • 6167
            #18
            More reviews? Seems like $15 well spend, after I take care of some more pressing issues.
            The first car I ever rode in was an e30

            Originally posted by Cabriolet
            Wish you the best and hope you don't remember anything after 10pm.



            1992 Mauritiusblau Vert
            2011 Alpinweiss 335is coupe

            2002 540i/6 Black/Black
            2003 GSX-R 750 (RIP)

              Comment

              • FLG
                No R3VLimiter
                • Sep 2011
                • 3165
                #19
                Originally posted by SoCalKidz
                Tips on the best way to install it? Trans in car no short shifter.
                Remove the drive shaft, remove transmission mount cross member and tilt it back, could loosen the motor mounts for more room. Be careful not to tip too much and send the fan into the radiator. With it tilted you can get a screw driver up there to pop the clip off.



                Sent from my Galaxy Nexus using Tapatalk 2
                -Build http://www.r3vlimited.com/board/showthread.php?t=295277

                  Comment

                  • NigelStu
                    E30 Modder
                    • Oct 2010
                    • 827
                    #20
                    These are going into my ChumpCar. No more flippy-floppy shift knob!

                    I figure it should take me a whole 5 min to install. Easy since the trans is already out of the car....
                    Ben
                    Thelma-Louise, the '88is Chump Car - back to M20 power!

                    2014 ChumpCar Season Schedule!
                    April 5-6 Autobahn, IL - Sat: 1st! Sun: 3rd
                    May23-25 Watkins Glen, NY: 4th, 5th, 4th
                    October 4 PittRace Sprints: 2nd in C-class
                    October 18-19 NCM, Bowling Green KY: 2nd, 1st!
                    Nov 1-2 Watkins Glen - Chumpionship - 1st car to exit the race with significant body damage :(

                    Find us on FB! Schaut Speed Motorsports

                      Comment

                      • nando
                        Moderator
                        • Nov 2003
                        • 34827
                        #21
                        Originally posted by 328ijunkie
                        Get em for the M3 carrier (oval type) and ill buy tons. Everything past the 95 M uses the oval carrier
                        this.

                        I would buy 2 immediately. I have a delrin bushing in my car now, it's fantastic and basically will never wear out.
                        Build thread

                        Bimmerlabs

                          Comment

                          • garagistic
                            Forum Sponsor
                            • Apr 2011
                            • 1712
                            #22
                            Tons in stock! Ready to ship.

                              Comment

                              • jaywood
                                R3V Elite
                                • Jul 2010
                                • 4528
                                #23
                                What else do you recommend replacing when installing this?

                                  Comment

                                  • camberwears
                                    Advanced Member
                                    • Sep 2010
                                    • 167
                                    #24
                                    So this will stop the shifter slop?
                                    sigpic www.camberwears.com Team16Niss-Meguiars-Underground Grafix -Mediagearbox

                                      Comment

                                      • Roysneon
                                        R3V Elite
                                        • Apr 2010
                                        • 4505
                                        #25
                                        Originally posted by camberwears
                                        So this will stop the shifter slop?
                                        It will certainly help, but if the rear carrier bushing, the bushing on the shifter rod and the shift selector rod end are crap then it won't make up for all of that.
                                        For all things 24v, check out Markert Motorworks!
                                        Originally posted by mbonanni
                                        I hate modded emtree, I hate modded cawrz, I hate jdm, I hate swag, I hate stanceyolokids, I hate bags (on cars), I hate stuff that is slowz, I hate tires.

                                        I am a pursit now.

                                          Comment

                                          • Dsun
                                            Grease Monkey
                                            • Jul 2011
                                            • 371
                                            #26
                                            ive got about 1inch of side to side play in my shifter. Would this take care of it?
                                            Had a smooth purchase transaction with me?
                                            Please share your feedback

                                              Comment

                                              • TimKninja
                                                R3VLimited
                                                • Mar 2009
                                                • 2131
                                                #27
                                                I ordered these through your ebay store, looking forward to install!!!

                                                Had a different set of Delrin bushings on my last car. Definetly an awesome upgrade.
                                                1985 325e M50TU(Sold)
                                                1991 318is Slicktop (Sold)
                                                1990 325is Brilliantrot S50/5 Lug Swapped.
                                                1992 525i Manual shitbox Winter Beater

                                                  Comment

                                                  • rocco16v
                                                    Member
                                                    • Mar 2012
                                                    • 83
                                                    #28
                                                    just ordered a set to put in while i do my shiftier rebuild

                                                      Comment

                                                      • Wh33lhop
                                                        R3V OG
                                                        • Feb 2009
                                                        • 11705
                                                        #29
                                                        Originally posted by 328ijunkie
                                                        Get em for the M3 carrier (oval type) and ill buy tons. Everything past the 95 M uses the oval carrier
                                                        Alternative in the meantime: http://www.akgmotorsport.com/catalog...e36%20Shifters
                                                        paint sucks

                                                          Comment

                                                          • garagistic
                                                            Forum Sponsor
                                                            • Apr 2011
                                                            • 1712
                                                            #30
                                                            Originally posted by Wh33lhop
                                                            Alternative in the meantime:

                                                            If enough people are interested in the oval type we will develop it.

                                                              Comment

                                                              Previous 1 2 3 4 5 12 template Next
                                                              Working...