Homemade Center Vent Gauge Pod

[vpilarrt]

I fabricated an "Alpina" style gauge pod for the center air vents. As you can see the gauges only take up 1 vent hole and I modded the other vent so that it can be pointed in 2 different directions (such as towards driver and towards passenger). The gauge panel/holder is made of a thin wood panel and is spray painted black and is a tight enough fit into the vent pod so that it doesn't need any glue. Gauges are new and are the VDO Vision Black series - water temp and oil pressure (~$40 each at Egauges.com).

Pod with gauges - $85 shipped in CONUS
Pod without gauges - $35 shipped in CONUS

[vpilarrt]

Bump. Am I asking too much?

[e34_spangler]

Personally I think its a bit big for the spot a smaller size gauge s would look better just my 2 cents

Sent from my SCH-I535 using Tapatalk 2

[Skunkworks]

I totally got exited thinking that was a lower vent. oh well GLWS

[vpilarrt]

Bump for price drop

[e34_spangler]

i think if it blended better, like if it almost looked like it was ment to be there? idk just my 2 cents again

[vpilarrt]

Bump

[HI-BOOST]

This may help you. Selling my gauge panel business since I no longer make them. http://www.r3vlimited.com/board/showthread.php?t=284189