PA: Complete M20i, G260, Driveshaft, Etc

[95///M3]

I will be pulling my M20 in 2 weeks and wanted to post it up anyone wanted to come drive it or here it run first.

1989 325i. Timing belt serviced 15k miles ago. Fully maintained. No leaks! Pulls extremely hard. Everything included, accessories, wiring harness, 173 DME, etc. Turner chip.

5spd Getrag 260. Shifts smooth. Lightened stock steel flywheel to 14lbs. New clutch, PP, tob, pilot bearing 15k miles ago.

Asking $800 for the running drivetrain.

Located in York, PA.

[swooper]

Hi. What can you tell me about the engine? Specifically:

Why are you selling?
How many miles?
Has it ever overheated or been rebuilt?
Do you have compression numbers?
How long have you owned it?

Thanks.

[Graebmw95]

Hi. What can you tell me about the engine? Specifically:

Why are you selling?
How many miles?
Has it ever overheated or been rebuilt?
Do you have compression numbers?
How long have you owned it?

Thanks.

I too am curious about this! Very interested in buying.


Sent from my iPhone using Tapatalk

[Replicam3cabrio]

Interested on the transmission.
PM sent

[Peelsbimmer]

If you are willing to part anything out. I'm interested in the flywheel, clutch, pp, tob etc..

[95///M3]

Hi. What can you tell me about the engine? Specifically:

Why are you selling?
How many miles?
Has it ever overheated or been rebuilt?
Do you have compression numbers?
How long have you owned it?

Thanks.

I have an M52 here and a 6 speed.
Mileage on chassis is 265k. I will get compression numbers and I invite anyone to come drive the car. It pulls HARD for an M20.
Never overheated since I have owned it. I was told the head was rebuilt when I purchased the vehicle. New guides and seals.
Compression numbers will be taken.
I have owned it since 2010.

I would almost prefer if the prospective buyer could drive the car to verify all claims.

Jim

[jwal]

I second on the flywheel, clutch, etc

[95///M3]

Trying to keep it all together initially.

Jim

[jwal]

Any updates on the fly setup?