I had a growler on my barn find at 105k so replaced both hubs and bearings. This was the good one and if the other side had not gone out I would still be running this. The bearing is tight and spins smooth with no lumpiness.
Personally I would never install a used part this critical but I know there are people who are stuck with cars they need daily and for lack of funds or time cannot do this the right way when a bearing goes out (by right way I mean replace both sides with OE or OEM parts).
I am offering this for emergency short term use only just to insure expectations are reasonable. I recommend you clean out as much of the old grease as possible and renew it.
Its $30 shipped CONUS
Personally I would never install a used part this critical but I know there are people who are stuck with cars they need daily and for lack of funds or time cannot do this the right way when a bearing goes out (by right way I mean replace both sides with OE or OEM parts).
I am offering this for emergency short term use only just to insure expectations are reasonable. I recommend you clean out as much of the old grease as possible and renew it.
Its $30 shipped CONUS
Comment